Operating principle of plastic dryer and convection drying technology
Plastic dryer is an indispensable equipment in plastic processing. Poor drying quality will directly affect the quality of the produced product. This shows the importance of plastic dryer. Today we will focus on, what is the method of plastic drying? What is the method of convection drying?
For non-hot-air hygroscopic materials, a hot-air plastic dryer can be used for drying. Because water is loosely restricted by the interfacial tension between the material and water, it is easy to remove. The principle of the plastic dryer is to use a fan to absorb the air in the environment and heat it to the temperature required for drying specific materials. The heated air passes through the drying hopper and heats the materials by convection to remove moisture.
In the drying technology of plastic dryers, the dew point temperature of the air is a very important parameter. The so-called dew point temperature is the temperature corresponding to when the relative humidity reaches 100% while keeping the moisture content of the moist air unchanged. It represents the temperature corresponding to when the air reaches the condensation of moisture. Generally, the lower the dew point of the air used for drying, the lower the amount of residual water obtained, and the lower the drying speed.
The energy required to dry the rubber particles consists of two parts, one part is the energy required to heat the material from room temperature to the drying temperature, and the other part is the energy required to evaporate the water. When determining the amount of gas required by the material, the plastic dryer is usually based on the temperature of the drying gas when it enters or leaves the drying hopper. Convection of a certain temperature of dry air to transfer heat to the rubber particles is also a convective drying process.
